ConvaTec inset guard User Manual

Infusion Care
Preparation
Before you start
1
Preparation
Before following the user steps described in this
user guide, please make sure to carefully read the
information and disclaimers in the bottom of the last
page. Please note that the information provided in
this guide is not a substitute for professional medical
advice or for reading the instructions for use (IFU)
that comes with the infusion set.
Insertion
5
Insertion
Open the blister pack and take out the contents.
Caution
Ensure sterility by checking if the packaging is undamaged.
Do not use if the infusion set is already open or has been
damaged.
Arrow guide
Pull
2
Preparation
Wash your hands before inserting the infusion set.
6
Insertion
Pull gently to remove the paper from the adhesive
tape. Be careful not to touch the adhesive tape.
inset
Push Point
3
Preparation
Choose an insertion site as recommended by your
healthcare provider. Do not use an area right next
to your previous infusion site.
7
Insertion
Remove the disconnect cover from the insertion
device by gently squeezing the sides of the
disconnect cover while pulling it straight out. Keep
the disconnect cover for later use.
guard infusion set
™
Twist
Preparation
Clean the area for insertion with a disinfectant as
directed by your healthcare provider. Be sure the
area is air dry before inserting the infusion set.
Insertion
Before placing the insertion device against the skin,
note that the arrows on the insertion device show
where the tubing will be connected after insertion.
User Guide
4
8
1