ConvaTec Natura+ System How To Use

How to Use the
Natura+ System
With Pre-Cut or Cut-to-Fit Skin Barriers

Step 1: Getting off to a Fresh Start

Begin by cleansing the skin around your stoma with warm water.
Rinse and pat dry thoroughly.

Step 2: Getting the Right Fit

Step 2: Getting the Right Fit Step 2: Getting the Right Fit
Measure the stoma and select the proper size Skin Barrier. Measure the stoma and select the proper size Skin Barrier.
■ For Cut-to-fit Skin Barriers:
Trace the stoma size on the centre of the white release
paper on the back of the barrier, and cut an opening about
2mm larger than your tracing.
■ For Pre-Cut Skin Barriers:
Select skin barrier with pre-cut stoma opening slightly
larger than your stoma.

Step 3: Applying the Skin Barrier to Your Skin

Remove the white release liner from the back of the barrier and
centre the opening over your stoma. centre the opening over your stoma.
Press the skin barrier in place. Smooth the inner edge
closest to your stoma with your fingers, holding for 30
seconds to ensure a snug fit around the stoma.

Step 4: Applying the White Border

If present, peel off the white release liner from the Tape Border
and press gently against skin, smoothing out any wrinkles.