ConvaTec inset II User Manual

Infusion Care
Preparation
Before you start
1
Preparation
Before following the user steps described in this
user guide, please make sure to carefully read the
information and disclaimers in the bottom of the last
page. Please note that the information provided in
this guide is not a substitute for professional medical
advice or for reading the instructions for use (IFU)
that comes with the infusion set.
Insertion
5
Insertion
Pull the red tape to remove the sterile plastic seal.
Caution
Ensure sterility by checking if the sterile paper and
tamperproof seal are undamaged. Do not use if the infusion
set is already open or has been damaged.
Arrow guide
Pull
2
Preparation
Wash your hands before inserting the infusion set.
6
Insertion
Remove the sterile paper.
Push Point
3
Preparation
Choose an insertion site as recommended by your
healthcare provider. Do not use an area right next
to your previous infusion site.
7
Insertion
To remove the lid, press the three raised dots on
each side of the lid firmly with one hand and lift up
the lid with the other hand.
Caution
Be careful not to bend or touch the introducer needle when
preparing the serter and infusion set.
inset II infusion set
™
Twist
Preparation
Clean the area for insertion with a disinfectant as
directed by your healthcare provider. Be sure the
area is air dry before inserting the infusion set.
Insertion
To unwind the tubing, carefully twist the beginning
of the tubing out of the slot. Now unwind the tubing
from the serter by pulling it carefully upwards.
Caution
Do not pull too hard when the tubing is fully released to
avoid accidentally lifting the infusion set from the serter.
User Guide
4
8
1