SUMMARY 1. Introduction 2. Specifications 3. Preparing the Product For Use 3.1. Unpacking 3.2. Installing the shaft 3.3. Installing the lever on the shaft and the rod on the chamber top 3.4. Attaching the lance to the trigger valve (starting and stopping) 3.5 Adjusting the strap 3.6.
1. Introduction 3. Preparing the Product For Use This manual contains information for the proper assembly, op- 3.1. Unpacking eration and care of your sprayer. Carefully read and follow the instructions contained in this manual before using your sprayer. Remove from the sprayer carton the following parts: This equipment was designed for spraying plants protection products approved by regulatory authorities to be used in back- Tank...
3.2. Installing the shaft 3.4. Attaching the lance to the trigger valve (starting and stopping) • Install the shaft (1) into the free hole on the sprayer base (chamber side). • Push the lance into the trigger valve and secure it with the screw cap.
3.7. Loosening • Invert the shoulder straps position as shown below. • Hold the buckle fi rmly with one hand, and pull the strap up- ward with the other hand. Buckle 3.9. Storage The sprayer should be stored in secure and ventilated place. Do 3.8.
Spray downwind and avoid drift Keep constant height Constant pressure Correct nozzle 4.2. Calibration of manual backpack sprayer Using calibrator bottle (optional). • Hold the lance at the working height and spray to measure the application band width. • Based on the band width, calculate the total walking distance required to spray the desired area.
4.4. Influence of climatic conditions During application, some factors may determine the interrup- tion of the spraying. Wind, for example, can drag drops to a greater or lesser distance in terms of its size or weight. The tem- perature and especially the relative humidity contribute to the rapid evaporation of the droplets.
Fastener Do not change the sprayer components. Always check for leaks or malfunction. Follow the maintenance instructions and use original parts provided by Jacto. Screwdriver Failure to follow the instructions may cause damage to the oper- ator’s health and the environment.
Valve Fastener Channel/ guide for fi tting the Cylinder fastener Fastene guide * Items not supplied with the product. 5.7. Triple rinse of empty agrochemicals containers NOTICE: Even the containers considered empty contain chemi- cal residues. Therefore, discarding the containers without wash- ing out the residues is extremely dangerous to man, animals and environment.
6. Critical Safety and Health Information • Put 1 gallon of water in a bucket and add the chemical prod- uct. WARNING! • Stir until it becomes an homogeneous mixture. Read carefully the chemicals manufacturer’s • Pour the solution into the tank while fi lling with water. labels.
Page 16
DANGER! Do not eat, drink or smoke while spraying. Serious risk of poisoning. WARNING! CAUTION! Do not pollute the environment. Principles Keep the products out of reach of children to preserve the environment, to recycle and animals. and dispose of any equipment, its parts and components correctly must be respected, taking in consideration the legislation in eff ect (municipal, state and federal) as well...
• JACTO reserves the right to modify its products or to interrupt the manufacture without prior notice. 6. Statement Of Limited Warranty MÁQUINAS AGRÍCOLAS JACTO S.A.
Need help?
Do you have a question about the CD Series and is the answer not in the manual?
Questions and answers