1. Manuals
  2. Brands
  3. Golden Designs Manuals
  4. Plumbing Product
  5. MX-M306-01
  6. Instruction manual

Golden Designs MX-M306-01 FS Instruction Manual

2 and 3 person infrared saunas
Hide thumbs Also See for MX-M306-01 FS:
Table of Contents

Advertisement

Quick Links

Download this manual
Infrared Sauna Instruction Manual
Models MX-M206-01 FS (SJ-8223) / MX-M306-01 FS (SJ-8323)
2 and 3 Person Infrared Saunas
INFRARED MODEL SAUNA
RED CEDAR MODELS
FOR INDOOR USE ONLY
120V/15AMP DEDICATED CIRCUIT REQUIRED FOR MX-M206-01 (SJ-8223)
120V/20AMP DEDICATED CIRCUIT REQUIRED FOR MX-M306-01 (SJ-8323)
Carefully and thoroughly read this Owner's Manual before using/operating the
sauna. We recommend keeping this Owner's Manual for regular review and future
reference. Follow your local codes and ordinances.
1

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the MX-M306-01 FS and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Related Manuals for Golden Designs MX-M306-01 FS

Summary of Contents for Golden Designs MX-M306-01 FS

  • Page 1 Infrared Sauna Instruction Manual Models MX-M206-01 FS (SJ-8223) / MX-M306-01 FS (SJ-8323) 2 and 3 Person Infrared Saunas INFRARED MODEL SAUNA RED CEDAR MODELS FOR INDOOR USE ONLY 120V/15AMP DEDICATED CIRCUIT REQUIRED FOR MX-M206-01 (SJ-8223) 120V/20AMP DEDICATED CIRCUIT REQUIRED FOR MX-M306-01 (SJ-8323) Carefully and thoroughly read this Owner’s Manual before using/operating the...

  • Page 2: Table Of Contents

    Thank you for choosing our Infrared sauna product! Table of Contents Packing List Assembly Diagram Schematics Schematic Layout Dimensional Diagram Screw Identification and Location Chart Highlights Assembly Instructions Operating the Sauna Tips for Using Your Sauna Safety Instructions Safeguards for Your Sauna Troubleshooting Guide Maintenance Warranty...

  • Page 3: Are Infrared Rays Safe

    What Are Infrared Rays? Infrared is the band of light we perceive as heat. We cannot see this band of light with the naked eye, but we can feel this type of light in the form of heat. Our sun produces most of its energy output in the infrared segment of the spectrum.
  • Page 4 3mG-5mG, and our Near Zero EMF/Full Spectrum models range at less than 3mG (NIR heaters range at about 5mG-7mG at the same approximate 2 inches) EMF Levels from Common Homes Sources After many years and numerous studies on EMF exposure, no government body including the Occupational Safety and Health Administration (OSHA) have established permissible exposure limits (PEL).

  • Page 5: How It Works

    HOW IT WORKS Infrared Saunas differ from traditional saunas in that they use infrared radiant energy to directly penetrate into the body's tissue to produce perspiration. Traditional saunas use steam to heat the air inside the sauna, which then heats your body until you begin to perspire.
  • Page 6 READ ALL INSTRUCTIONS THOROUGHLY BEFORE ASSEMBLY MX-M206-01 FS (SJ-8223) – Assembly Diagram *THE ABOVE ASSEMBLY DIAGRAM IS FOR A QUICK REFERENCE VISUAL GUIDE ONLY. ALL SAUNA MODELS MAY NOT BE SHOWN. PARTS AND ACCESSORIES DO VARY AND ARE SUBJECT TO CHANGE.
  • Page 7 READ ALL INSTRUCTIONS THOROUGHLY BEFORE ASSEMBLY MX-M306-01 FS (SJ-8323) – Assembly Diagram *THE ABOVE ASSEMBLY DIAGRAM IS FOR A QUICK REFERENCE VISUAL GUIDE ONLY. ALL SAUNA MODELS MAY NOT BE SHOWN. PARTS AND ACCESSORIES DO VARY AND ARE SUBJECT TO...
  • Page 8 READ ALL INSTRUCTIONS THOROUGHLY BEFORE ASSEMBLY MX-M206-01 FS (SJ-8223) – Schematics *THE PICTURES AND DIAGRAMS SHOWN WITHIN THIS OWNER’S MANUAL ARE REPRESENTATIONS OF THIS MODEL. ACTUAL MODEL MAY VARY. DESIGN AND CONSTRUCTION ARE SUBJECT TO CHANGE. BACKRESTS NOT INCLUDED.
  • Page 9 READ ALL INSTRUCTIONS THOROUGHLY BEFORE ASSEMBLY MX-M306-01 FS (SJ-8323) – Schematics *THE PICTURES AND DIAGRAMS SHOWN WITHIN THIS OWNER’S MANUAL ARE REPRESENTATIONS OF THIS MODEL. ACTUAL MODEL MAY VARY. DESIGN AND CONSTRUCTION ARE SUBJECT TO CHANGE. BACKRESTS NOT INCLUDED.
  • Page 10 READ ALL INSTRUCTIONS THOROUGHLY BEFORE ASSEMBLY MX-M206-01 FS (SJ-8223) – Schematic Layout *THE PICTURES AND DIAGRAMS SHOWN WITHIN THIS OWNER’S MANUAL ARE REPRESENTATIONS OF THIS MODEL. ACTUAL MODEL MAY VARY. DESIGN AND CONSTRUCTION ARE SUBJECT TO CHANGE.
  • Page 11 READ ALL INSTRUCTIONS THOROUGHLY BEFORE ASSEMBLY MX-M206-01 FS (SJ-8223) – Schematic Layout (cont’d) *THE PICTURES AND DIAGRAMS SHOWN WITHIN THIS OWNER’S MANUAL ARE REPRESENTATIONS OF THIS MODEL. ACTUAL MODEL MAY VARY. DESIGN AND CONSTRUCTION ARE SUBJECT TO CHANGE.
  • Page 12 READ ALL INSTRUCTIONS THOROUGHLY BEFORE ASSEMBLY MX-M306-01 FS (SJ-8323) – Schematic Layout *THE PICTURES AND DIAGRAMS SHOWN WITHIN THIS OWNER’S MANUAL ARE REPRESENTATIONS OF THIS MODEL. ACTUAL MODEL MAY VARY. DESIGN AND CONSTRUCTION ARE SUBJECT TO CHANGE.
  • Page 13 READ ALL INSTRUCTIONS THOROUGHLY BEFORE ASSEMBLY MX-M306-01 FS (SJ-8323) – Schematic Layout (cont’d) *THE PICTURES AND DIAGRAMS SHOWN WITHIN THIS OWNER’S MANUAL ARE REPRESENTATIONS OF THIS MODEL. ACTUAL MODEL MAY VARY. DESIGN AND CONSTRUCTION ARE SUBJECT TO CHANGE.
  • Page 14 MX-M206-01 FS (SJ-8223) – DIMENSIONAL DIAGRAM...
  • Page 15 MX-M206-01 FS (SJ-8223) – DIMENSIONAL DIAGRAM (cont’d) *THE PICTURES AND DIAGRAMS SHOWN WITHIN THIS OWNER’S MANUAL ARE REPRESENTATIONS OF THIS MODEL. ACTUAL MODEL MAY VARY. DESIGN AND CONSTRUCTION ARE SUBJECT TO CHANGE.
  • Page 16 MX-M306-01 FS (SJ-8323) – DIMENSIONAL DIAGRAM...
  • Page 17 MX-M306-01 FS (SJ-8323) – DIMENSIONAL DIAGRAM (cont’d) *THE PICTURES AND DIAGRAMS SHOWN WITHIN THIS OWNER’S MANUAL ARE REPRESENTATIONS OF THIS MODEL. ACTUAL MODEL MAY VARY. DESIGN AND CONSTRUCTION ARE SUBJECT TO CHANGE.

  • Page 18: Screw Identification And Location Chart

    SCREW IDENTIFICATION AND LOCATION CHART...

  • Page 19: Highlights

    Highlights A. High quality craftsmanship B. Temperature control C. Timer D. Infrared carbon heat emitter panels E. Control Panel: F. Power supply and sub power supply: G. MP3 Jack: H. Buckles:...
  • Page 20 Assembly Assembly Requirements Please note that your sauna has been completely assembled and tested at the factory prior to packaging. Please further note that the rear wall panel is intentional warped as part of the overall design. Two adults will be needed to assemble the sauna room.
  • Page 21 which side is the back. The front of the floor will have a slant. The back does not have a slant. See FIG-2 Front and Sides have a slant FIG-2 Placing Floor Panel 5. Place the Back Panel up and onto the Floor Panel. One adult will need to hold the Back Panel while the other adult continues to the next step.
  • Page 22 FIG-4 Assembling Left Side Panel FIG-5 Buckle 7. Latch the Left Side Panel with the Back Panel. The buckle has a guide tab that must be placed in the guide slot for alignment. When the Back Panel and the Side Panel are attached together on the Floor Panel, make sure all the buckles are latched tight.
  • Page 23 9. Latch the Right Side Panel with the Back Panel. The buckle has a guide tab that must be placed in the guide slot for alignment. When the Back Panel and the Side Panel are attached together on the Floor Panel, make sure all the buckles are latched tight. See FIG-4 and FIG-5 10.
  • Page 24 sure the cords are connected snug and tight. You can use the provided screws to secure the bench in place. FIG-9 Bench Heater Assembly 12. Place the Front Panel up and onto the Floor Panel and align it with both the Left and Right Side Panels.
  • Page 25 14. Place cords/wires of Front Panel, Back Panel, and Side Panels into the sauna room area to avoid damaging the cords/wires during the roof installation. Open the door, lift the Roof Panel up and over the sauna room and gently lower it into place resting it on the wall panels.
  • Page 26 FIG-14 Roof Dust Cover Assembly Attach the door handle and screw into place. See FIG-15 FIG-15 Door Handle Installation Assembly Completed.

  • Page 27: Operating The Sauna

    Operating the Sauna NOTE: Please check and confirm that the connections to the POWER SUPPLY, HEAT EMITTERS, and TEMPERATURE SENSOR are connected properly. The power supply voltage and frequency must match the requested voltage and frequency of the sauna (120VAC 15AMP Dedicated Circuit or 120VAC 20AMP Dedicated Circuit).
  • Page 28 the complete sauna will turn OFF. B. Start Sauna: Press the “ “ button and the system will enter the heating mode. Press the “ “ to Start/Stop the sauna’s heating. If the icon is red, then the heating is stopped. If the icon is green, then the heating is activated.
  • Page 29 Either the Red Light Therapy or the Interior Lights can be ON at any given time. They cannot be operated simultaneously. 1. Press the “ “ button to turn ON/OFF the Exterior Lights (DC12V). 2. Press the “ “ button to turn ON/OFF the Red Light Therapy (DC12V). 3.
  • Page 30 H. You can press the “ “ to return back to the main interface mode. I. Drink water prior to, during, and after your sauna session to replenish body fluids. J. After 3 hours of continuous use, the sauna needs to be shut down for one hour. K.

  • Page 31: Tips For Using Your Sauna

    Use 2 towels during your sauna session. Fold the first towel several times and place it on the bench. As you sit on this towel, it will absorb a majority of your perspiration while adding comfort as you sit on the bench. Use the second towel to either constantly wipe the perspiration from your body to perspire faster and also to avoid having too much perspiration dripping onto the floor.

  • Page 32: Safety Instructions

    sauna session. 8. To treat your ankles and feet more effectively, you can elevate them and move them close to one of the heat emitters to achieve a deep heating effect. 9. To utilize the sauna’s heat therapy effect, put oil and treatment into your hair and wrap it with a towel.
  • Page 33 rate, blood pressure, and/or blood circulation. 10. Use care when exercising before and after sauna use. 11. Never sleep inside the sauna 12. Do not use any type of cleaning agents on the interior of the sauna. Only wipe down the sauna room with water and a damp cloth.

  • Page 34: Safeguards For Your Sauna

    Safeguards For Your Sauna 1. Do not install the sauna near water, near a bathtub (if water will splash on the sauna), near a shower (if water will splash on the sauna), in a wet basement, or near a swimming pool (if water will splash on the sauna). 2.
  • Page 35 2. Control Panel Malfunctioning Solution: The control panel will turn on, but not off and the displayed numbers flash. The issue may be a connection problem. Go up to the roof and locate the “CTRL” wire harness you connected when the roof was installed onto the sauna room.

  • Page 36: Maintenance

    the roof of the sauna. Make sure the wiring harness labeled “CTRL” is connected to the power supply at one end and connected to another wiring harness labeled “CTRL” at the other end. If this wiring harness is not properly connected, then the sauna will show signs of having no power.

  • Page 37: Limited Lifetime Warranty

    Limited Lifetime Warranty 5 Year Limited Warranty*: Golden Designs, Inc. under the Maxxus brand name warranties the wood, structure, heating elements, and electronics against defects in material and workmanship for a period of 1 to 5 years from the original date of purchase. This sauna is for INDOOR use only.
  • Page 38 ▪ Outdoor applications ▪ Normal wear and tear or weathering ▪ Use of product not in accordance with instructions ▪ Worn out receptacle Surface cracks are not considered defects in material or workmanship, as they are normal characteristics of all woods. This includes minor cracks due to wood expansion and contraction.

  • Page 39: Warranty Card

    WARRANTY CARD Congratulations on your purchase of an Infrared Sauna from Golden Designs, Inc. Please take the time to complete the following Warranty Card and mail it back to: Golden Designs, Inc. 3550 Jurupa Street, Unit B Ontario, CA 91761 Please include a copy of your sales receipt showing date of purchase as this will serve as proof of purchase.

This manual is also suitable for:

Mx-m206-01 fsSj-8223Sj-8323

Table of Contents