Network - Devon IT OptiPlex VDI Blaster Edition Administration Manual

4
Enter a password in the password field and re-enter it to confirm your
password.
5
Press the Apply button to save your password.
NOTE: Once a system password is set, the user will be prompted for the password when
they attempt to open the Control Panel. If the Cancel button is pressed or a user
incorrectly types the password, then the Control Panel will open in a read-only mode. A
small padlock icon will also appear along the bottom of the Control Panel window,
indicating that edits are not allowed. Keep your password safe!

Network

By default, the thin client attempts to contact a DHCP server on your network
during boot up. If you have a DHCP server on your network, then the thin client
will acquire an IP address automatically and no further network configuration is
required on your part.
If you need to set a Static IP address on a DeTOS thin client:
1
From the DeTOS Desktop, select DeTOS-> Control Panel.
2
Select the Network icon on the left-hand side of the Control Panel under
System.
3 Select the Network Interfaces tab found near the top of the window,
then select eth0.
4
Deselect the Use DHCP checkbox.
5
Type in appropriate values for the IP Address, Netmask, and Gateway
address fields and then press Apply.
6
Sometimes, depending on your network, it may take 15-20 seconds to
reconfigure to the Static IP. This is normal, and a reboot is NOT required.
30 | Connections