Input/Time - Devon IT OptiPlex VDI Blaster Edition Administration Manual


Left of or Right of -If your monitors are positioned in a side-by-side
arrangement, then you'll want to specify one of the monitors as being to
the Left of or Right of the opposite monitor.

Above or Below-If your monitors are positioned in a top and bottom
arrangement, then you'll want to specify one of the monitors as being to
the Above or Below the opposite monitor.

Clone-Choosing the Clone option will cause the display to be duplicated
on both monitors. (Also known as "Mirrored.")
NOTE: This is the default behavior for dual monitors when powered on for the
first time.

Offset-When you select the offset option, you will be presented with two
additional fields for X and Y coordinates. For example: 50x50 will
cause the display to be positioned 50 pixels left of and 50 pixels higher
than its normal centered state.

Rotation-Select Right to rotate the display clockwise and Left to rotate
the screen counter-clockwise. You can also select Invert to flip the entire
display upside down.

Reflection-Select X, Y, or XY values to rotate the screen along the XY
plane.
NOTE: The X plane is Horizontal. The Y plane is Vertical.
Once you are finished, press the Apply button and reboot the thin client for the
changes to take effect.

Input/Time

This section allows you to configure keyboard, mouse, and time settings for the
terminal.
1 From the DeTOS Desktop, select DeTOS->Control Panel.
2
Select the Input/Time icon on the left-hand side of the Control Panel
under System
.
Connections | 25