Front I/O Panel Housing Assembly
Prepare the computer for disassembly
1.
Remove the access panel and rotate the computer so the system board is parallel to the table to make
2.
it easier to work on
Remove the front bezel
3.
Free the two cables from the cable tie that is attached to the chassis.
4.
Remove the screw (1) that secures the housing to the chassis and then rotate the housing away from
5.
the chassis and pull the assembly out of the chassis.
To install the housing assembly, reverse the removal procedures.
54
Chapter 7 Removal and Replacement Procedures— Microtower (MT) Chassis
(Preparation for Disassembly on page
(Access Panel on page
(Front Bezel on page
38)
39)
37)
ENWW