Speaker - HP dx2308 - Microtower PC Service & Reference Manual

Speaker

Prepare the computer for disassembly
1.
Remove the access panel
2.
Remove the front bezel
3.
Disconnect the speaker cable from the system board.
4.
Free the cable from the cable tie that is attached to the chassis.
5.
Remove the screw that secures the speaker to the inside of the chassis (1) then, remove the speaker
6.
(2) by sliding it out of the retaining clips..
To install the speaker, reverse the removal procedure.
When installing the speaker, make sure the speaker wires point towards the speaker retaining screw.
56 Chapter 7 Removal and Replacement Procedures— Microtower (MT) Chassis
(Preparation for Disassembly on page
(Access Panel on page
(Front Bezel on page 39)
38)
37)
ENWW