5.25" Drive - HP dx2308 - Microtower PC Service & Reference Manual

5.25" Drive

Prepare the computer for disassembly
1.
Remove the access panel
2.
Remove the front bezel
3.
Disconnect the power, data, and audio cables, as necessary, from the back of the drive.
4.
Remove the two screws that secure the drive in the drive cage (1).
5.
Slide the drive out of the drive cage, as shown in the illustration below (2).
6.
After the drive has been removed from the chassis, remove the two guide screws from the left side
7.
of the drive. These screws should be transferred to the new drive.
To install a drive, reverse the removal procedure.
NOTE:
metal shield that covers the bay by pressing in on the silver-colored tab on the left side of the chassis
then pulling the shield out from the front of the chassis. It is not necessary to remove the drive from
bay 1 when performing this operation.
NOTE:
the bezel. Four have Unified Standard (US) #6–32 standard threads and for have M3 metric
threads. US screws are used for used for hard drives and have a silver finish. Metric screws are
used for all other drives and have a black finish. Be sure to install the appropriate guide screws
into the drive.
50 Chapter 7 Removal and Replacement Procedures— Microtower (MT) Chassis
(Access Panel on page
(Front Bezel on page
If you are installing a 5.25" drive for the first time into bay 2 you must first remove the
There are a total of eight extra guide/retainer screws on the front of the chassis behind
(Preparation for Disassembly on page
38)
39)
37)
ENWW