Power Switch Assembly - HP dx2290 - Microtower PC Service & Reference Manual

Power Switch Assembly

1. Prepare the computer for disassembly
2. Remove the access panel
3. Lay the computer down on its side for greater stability.
4. Disconnect the braided cable from the system board.
5. If necessary, remove the cable from the clips on the drive cage.
6. Squeeze the top of the switch holder (1), slide the switch down (2), and then remove it from the
chassis.
To install the power switch assembly, reverse the removal procedures making sure that you tuck the
wires out of the way to clear the front bezel.
(Preparation for Disassembly on page
(Access Panel on page 28).
Power Switch Assembly
26).
49