Removal and Replacement Procedures— Microtower (MT) Chassis
6.4 Front Drive Bezels
1. Prepare the computer for disassembly
2. Remove the access panel
3. Remove the front bezel
6.4.1 5.25" Drive Bezel Blank
While facing the inside of the front bezel, press the two retaining tabs on the right towards the
outer edge of the bezel 1 and pull the bezel blank inwards to remove it 2.
To install a bezel blank, slide the left side of the blank into the two retainer slots on the left side
of the front bezel then snap the right side of the blank into place.
6–4
(Section 6.1, "Preparation for
(Section 6.3, "Front
Bezel").
(Section 6.3, "Front
Bezel").
415606-001
Disassembly").
Service Reference Guide, dx2200 MT