Access Panel - HP dx2200 - Microtower PC Service & Reference Manual

Removal and Replacement Procedures— Microtower (MT) Chassis

6.2 Access Panel

1. Prepare the computer for disassembly
Ä
CAUTION: Before removing the computer access panel, ensure that the computer is turned off and that
the power cord is disconnected from the electrical outlet.
2. Disconnect the power cord from the computer and from the power source 1.
3. Remove the two screws that secure the access panel to the computer chassis 2.
4. Slide the access panel back about 6 mm (1/4 inch), then rotate the top of the panel away from
the chassis (pivot on the bottom) and lift it off the unit 3.
To replace the access panel, reverse the removal steps.
6–2
(Section 6.1, "Preparation for
415606-001
Disassembly").
Service Reference Guide, dx2200 MT