HP dx2200 - Microtower PC Service & Reference Manual page 80

POST Error Messages
POST Error Messages
Screen Message
Primary Master/Slave
Hard Disk Error
Secondary Master/
Slave Hard Disk Error
Primary Master/Slave
Drive — ATAPI
Incompatible
Secondary Master/
Slave Drive — ATAPI
Incompatible
S.M.A.R.T. Capable but
Command Failed.
S.M.A.R.T. Command
Failed
S.M.A.R.T. Status Bad,
Backup and replace.
S.M.A.R.T. Capable
and Status Bad.
DMA-1 Error
DMA-2 Error
DMA Controller Error
Checking
NVRAM...Update
Failed
C–2
Probable Cause
Primary Master/Slave
hard drive could not be
initialized by the BIOS.
Secondary Master/Slave
hard drive could not be
initialized by the BIOS.
Device configured as a
Primary/ Master/Slave
failed an ATAPI
compatibility test.
Device configured as a
Secondary/ Master/
Slave failed an ATAPI
compatibility test.
BIOS unable to send a
S.M.A.R.T. message to
the device.
S.M.A.R.T. capable hard
drive detects an imminent
failure.
Error when initializing
secondary DMA
controller.
POST error while trying to
initialize the DMA
controller.
BIOS could not write to
the NVRAM block.
415606-001
Recommended Action
Reseat the device data and power
cables.
Replace the device data cable.
Replace the device.
Replace the system board.
Reseat the device data and power
cables.
Replace the device data cable.
Replace the device.
Replace the system board.
Replace the device.
Replace the system board.
Replace the device.
Replace the system board.
Backup the data on the hard drive.
Replace the hard drive.
Backup the data on the hard drive, then
replace the hard drive.
Reconnect the cables on the peripheral
device.
Replace the data cable.
Replace the device.
Replace the system board.
Reconnect the cables on the peripheral
device.
Replace the data cable.
Replace the device.
Replace the system board.
Change system board jumper on JP2 to
pins 2-3 (Unlock), then flash the system
BIOS. Reset the jumper to pins 1-2 (Lock).
Replace the system board.
Service Reference Guide, dx2200 MT