F&F FOX Double Switch-D Manual page 11

Restore factory settings
If you are unable to access the controller, we recommend that
you restore the controller to factory settings and reconfigure it
using the Fox app.
To restore the factory settings, proceed as follows
1. While the controller is operating, press and hold the PROG
button on the front of the controller. When the button is pres-
sed, the green LED will start to flash rapidly.
2. After about 5 seconds, the LED will turn off and you should
release the PROG button.
3. Press the PROG button briefly, the green LED will light up aga-
in.
4. Press and hold down the PROG button. After about 3 seconds,
the previously switched on green LED control light will start
to flash. After another 3 seconds, it will go out and the red
LED light up.
5. Release the button – after a few seconds the indicator LED will
turn green and the controller will restart.
6. After completing this procedure, the access passwords and
parameters for remote access have been cleared. You can
now search for your device again in the app and personalize
it again.
- 11 -