Extron electronics DMP 64 Plus C V AT Setup Manual page 6

Extron Certified DSP Bundle for Microsoft
Guide
Figure 8. Control Cockpit Exclusion Zones Adjustment
Dante Controller Setup
Dante Controller from Audinate
monitor performance.
Creating Subscriptions Between the Sennheiser TCC M and the Extron DMP 64 Plus C V AT
1.
Ensure the laptop, DMP 64 Plus C V AT (Dante), and TCC M (Dante) are connected to the same network.
2. From the Windows Start menu select: All Programs > Audinate > Dante Controller. The Dante Controller - Network
View screen opens. The Dante Controller auto-discovers Dante devices on the network and advertises itself to allow other
Dante-enabled devices to communicate with it. Transmitters connect to receivers using the subscription matrix.
Figure 9. Routing Tab of the Dante Controller Network View
NOTE:
The DMP 64 Plus C V AT and TCC M Dante connections are set to DHCP by default. If they cannot be
discovered, ensure the correct interface is selected on the PC by selecting Interfaces from the File menu.
3.
Open the Device View of the DMP 64 Plus C V AT by double-clicking the device name in the Routing tab.
6
is required to route transmitters and receivers, and can be used to configure Dante settings and
®
Teams Rooms – Medium Room • Setup
® ®