Extron electronics DMP 64 Plus C V AT Setup Manual page 12

Extron Certified DSP Bundle for Microsoft
Guide
IPCP Pro 250 xi Setup
The Control Processor in this system facilitates the communication between the Extron DMP Plus and Sennheiser TCC M.
Get Ready
1. Download and install the latest version of the following software:
• Toolbelt — for discovering the control processor and other control products on the network, for managing core settings,
and for upgrading firmware when needed.
• Global Configurator Plus and Professional (GCP) — for configuring the control system
2.
Obtain network information for the unit from the network administrator. You also need the following details for each Extron Pro
series Ethernet-enabled device:
• DHCP setting (on or off)
• LAN IP address
• AV LAN IP address
NOTE: If DHCP is on, you do not need the IP addresses and subnet mask.
3.
Write down the MAC address of each network interface on each IP Link Pro device to be used.
4. Obtain model names and setup information for devices the IPCP controls.
Mount and Cable All Devices
1. Cable devices to the control processor.
2. Connect power cords and power on all the devices.
Network Communication Setup
Network setup is essential prior to configuration. Use the flowchart at
right as a guide to setting up the control processor for network use.
NOTE: If using 802.1X security, see the Extron 802.1X
Technology Reference Guide and the Toolbelt Help file for
additional details on system setup.
12
Teams
®
• Subnet mask
• Gateway IP address
Rooms – Medium Room • Setup
®
• Username
• Passwords
Network Communication Setup
Connect the PC and the LAN port or AV LAN
port of the control processor to
the same network.
Apply power to all devices.
Open the Toolbelt software from within
Global Con gurator (GC Professional or
GC Plus mode) or as the stand-alone
application.
Start Device Discovery.
Toolbelt displays a list of all Extron control
devices connected to the network.
Using the MAC address, locate the desired
control processor in the list and select it.
For each network interface
(LAN, or LAN and AV LAN), use the Set IP
feature in Toolbelt or use the
Toolbelt Manage > Network Settings tab
feature to enter the IP address and
subnet address, then con gure other
network settings as needed.