Extron electronics DMP 64 Plus C V AT Setup Manual page 11

Extron Certified DSP Bundle for Microsoft
Guide
5. When a connection type with a device is established, the Synchronize with Device dialog box opens. Select Push the
data....
Synchronize with Device
DSP
You have elected to change from Emulate mode to live mode. The data in
this configuration must be synchronized with the data in the device. Please
select an option below to continue:
Pull data from the device and update this configuration.
Push the data from this configuration to device, overwriting any data
currently in it. The device will disconnect after the push if the
configuration and all the presets are not sent.
Push Configuration
Push AT Input Channel Names
Push Presets
All
Selected
NOTE: Pushing presets may cause the device to
cycle through each preset that is pushed. This
should not be performed during live operation.
Figure 19. Synchronize with Device Dialog Screen
6. Click OK. The DSP Configurator software pushes the template settings to the DMP, where they are saved.
Once the push is completed, the current state of the connected DMP 64 Plus C V AT is displayed in the DSP Configurator
status panel and the device is ready for further configuration.
USB Naming
The USB Audio tab allows for customizing USB audio interface names and
terminal types (see figure 20).
NOTE: Extron recommends configuring these settings before
connecting USB audio devices to a PC.
To configure USB audio settings in DSP Configurator:
1.
From the Tools menu, select Device Settings. The Device Settings
dialog box opens.
2.
Click the USB Audio tab.
3. In the USB Name field, enter the desired name for the USB audio
interface.
4. In the USB Terminal Type panel, choose Echo Cancelling
Speakerphone.
5. Click Apply to activate the new settings.
6. Connect the USB Audio port to the PC.
OK Cancel
Teams Rooms – Medium Room • Setup
® ®
Device Settings
DSP
Unit Info IP Settings Passwords Serial Settings
Date/Time
Enter a USB Name for the USB Audio interface.
To restore the default name, clear the field and
click Apply.
USB Name :
USB Name can be up to 32 characters drawn from the
alphabet (A-Z), digits (0-9), and special characters
including underscore(_), backslash(\), and spaces.
USB 1 Terminal Type
Appear as:
Figure 20.
?
USB Audio Dante Device
Extron DMP Plus
Echo Cancelling Speakerphone
Speakerphone
OK Cancel
USB Audio Tab
Apply
11