Table of Contents
Advertisement
Error code Error message
Controller does not support Chassis Name
2850
Invalid Chassis Name
2851
Invalid SSP State
2852
Cannot change SSP settings
2853
Invalid SSP Adapter ID
2854
Invalid Surface Scan Delay
2857
Controller does not support redundancy
2861
settings
Invalid Preferred Path Mode
2864
Invalid Preferred Path
2865
Failure opening capture file <text>
2866
Failure opening input file <text>
2867
Failure opening error file <text>
2868
There are no suitable spares available
2877
Invalid Physical Disk Type Specified
2880
Invalid MNP delay
2882
Invalid Option
3000
Command Failed
3002
License Key Delete Failed
3003
Invalid Sector Size
3004
Cannot delete Array
3005
Invalid Number of Parity Groups
3006
Chassis name is too long
3007
Chassis name is already in use
3008
Auto Configure failed
3009
Cannot extend logical drive, not enough
3010
free space for the requested size
Cannot extend logical drive, requested size
3011
is too small
Cannot specify both SIZE and SHRINKSIZE The input file cannot specify both a SIZE and
3012
Comment or clarification
The controller does not support setting a chassis
name.
The entered chassis name is invalid. Use characters
from the set a–z, A–Z, 0–9, !, @, #, *, (, ), ,, -, _, +,
:, ., /, and [space]. The name cannot end with a
space character or exceed the maximum number of
characters allowed by the controller.
The requested SSP state is not a valid SSP state.
The SSP settings cannot be changed for the controller
or logical drive.
The adapter ID is not a valid adapter ID that was
detected by the controller.
—
The controller is not redundant or does not support
redundancy settings.
The specified value for the preferred path mode is
not valid, or the controller is not available.
The specified preferred path is not a valid chassis
slot for an available, active controller, or the
controller is not available.
—
—
—
ACU found no drives that could be used as spares
for the specified array.
—
The specified value for MNP delay is invalid.
The value of the option supplied to this parameter is
invalid.
The controller returned an error for a command.
ACU is unable to delete the license key.
—
—
—
—
Another controller is already using the entered
chassis name.
The Auto Configure mode was unable to complete
auto configuration.
—
—
HP Array Configuration Utility 96
Advertisement
Table of Contents
