Table of Contents
Advertisement
•
Operating system device names or mount points
Performing a Diagnostics task
Open ACU.
1.
For more information, see "Using the ACU GUI (on page 31)."
If ACU is already open, click the Diagnostics/SmartSSD tab.
The Diagnostics/SmartSSD screen appears with the following selections:
View SmartSSD Wear Gauge Report
o
Generate SmartSSD Wear Gauge Report
o
Run Array Diagnostic Reports
o
For this example, use the diagnostic reports selection.
Select Run Array Diagnostic Reports.
2.
The array diagnostic report screen appears.
Select a device or devices from the Report Contents panel.
3.
The Available Tasks panel appears. For more information, see "Diagnostics tasks (on page 48)."
Click one of the task buttons:
4.
If you select Generate Diagnostic Report, wait for the report to generate, and then click Close Report
o
or Save Report.
If you select View Diagnostic Report, the report appears. When you are finished viewing the current
o
report, click Close Report, Refresh Report, or Save Report.
If you select View Serial Output Logs, the log appears. When you are finished viewing the log, click
o
Close Logs.
HP Array Configuration Utility 49
Advertisement
Table of Contents
