Table of Contents
Advertisement
</LogicalDrive>
</Array>
</Controller>
</Config.document>
XML input
XML input follows the same format as the document for XML output (on page 90). Use the same parameter
order as the standard input format.
The following example shows a simple input script in both standard and XML formats.
Standard format
Action= Configure
Method= Custom
Controller= Slot 1
Array=A
Drive= 1I:4:8, 1I:4:7
LogicalDrive= 1
RAID= 0
Size= 100000
XML input file DTD
The following DTD outlines the parameters for an ACU scripting XML input file.
<!DOCTYPE Config.document [
<!ELEMENT Config.document ( Action, Method, Controller+ ) >
<!ELEMENT Action ( Configure | Reconfigure ) >
<!ELEMENT Method ( Auto | Custom ) >
<!ELEMENT Controller,
ClearConfigurationWithDataLoss | DPOEnable? | DriveWriteCache? |
ElevatorSortEnable? | ExpandPriority? | IRPEnable? | Initiator? |
LicenseKey? | MNPDelay? | PreferredPathMode? | QueueDepth? | ReadCache? |
RebuildPriority? | SurfaceScanDelay? | WriteCache? ) >
<!ATTLIST Controller ID PCDATA #REQUIRED >
<!ELEMENT ClearConfigurationWithDataLoss ( YES | NO ) NO >
<!ELEMENT DPOEnable ( YES | NO ) >
<!ELEMENT DriveWriteCache ( ENABLE | DISABLE ) >
<!ELEMENT ElevatorSortEnable ( YES | NO ) >
<Raid>5</Raid>
<Size>52478</Size>
<Sectors>32</Sectors>
<StripeSize>64</StripeSize>
<ArrayAccelerator>Enabled</ArrayAccelerator>
XML format
<?xml version="1.0"?>
<Config.document>
<Action>Configure</Action>
<Method>Custom</Method>
<Controller ID="Slot 1">
</Controller>
</Config.document>
Array ) ChassisName? |
<Array ID="A">
<Drive>1I:4:8, 1I:4:7</Drive>
<LogicalDrive ID="1">
<Raid>0</Raid>
<Size>100000</Size>
</LogicalDrive>
</Array>
HP Array Configuration Utility 92
Advertisement
Table of Contents
