THORLABS PM130D Quick Reference page 5

2 Unpacking
Inspect the shipping container for damage.
If the shipping container seems to be damaged, keep it until you have in-
spected the contents and you have inspected the PM100D mechanically and
electrically.
Verify that you have received the following items within the hard-case:
1. PM100D power/energy meter console
2. 8 GB SD memory card – installed in PM100D
3. Plug-In power supply with Interchangeable primary plug for USA, UK,
Europe, and Australia
4. USB cable, type 'A' to 'mini-B'
5. Quick-start guide
6. Certificate of Calibration
3 Operating the PM100D
3.1 Preparation
Configure the plug-in power supply with the primary plug for your local power
supply.
Connect a suitable power or energy sensor. The sensors have a self-fixing
mechanism. To plug or unplug a sensor slightly press from both sides on the
pins in the connector housing.
Turn the unit on by pressing the power button in the side panel.
After switching on the unit, the graphics display will show the device status
and then jump to the last measurement screen before power down.
The PM100D is immediately ready to use after turning on.
© 2023 Thorlabs
Unpacking 5