Installing The Storageworks Command Console (Swcc) Client; Configuring A Storage Subsystem For Secure Path Operation - Compaq 112726-001 - ProLiant - 6500 Administrator's Manual

5-22 Compaq Parallel Database Cluster Model PDC/O5000 for Oracle8i and Windows 2000 Administrator Guide
Installing the StorageWorks Command Console
(SWCC) Client
Configuring a Storage Subsystem for Secure Path
Operation
2. Connect each storage subsystem's controller enclosure and disk
enclosures to a guaranteed power source.
3. Power on all storage subsystem enclosure components as specified in
the user documentation for the storage subsystem.
4. Power up all servers in the cluster.
The storage subsystem is ready to operate when the green LED in the pushable
RESET button on the array controller blinks at a rate of one time per second.
This takes about one minute to occur.
Install the SWCC Client software on the node designated as the maintenance
server.
To install the SWCC Client:
1. Insert the MA8000/EMA12000 Solution Software CD into the
CD-ROM drive.
2. Run Windows Explorer.
3. Navigate to the folder DRIVE_LETTER:\SWCC\CLIENT (where
DRIVE_LETTER identifies the letter for the CD-ROM drive).
4. Select Intel Client. Double-click on Setup.
5. Follow the setup wizard instructions to complete the installation.
6. Restart the server.
Each new MA8000/EMA12000 Storage Subsystem is preconfigured with
specific parameters. You may need to change these parameters, depending on
which Fibre Channel SAN topology and cluster configuration you use. This
subsection reviews the steps required to make these changes.