Using The Setup Password - Dell PowerEdge NM176 Hardware Owner's Manual

5 Confirm that Not Enabled is displayed for the System Password option.
If Not Enabled is displayed for the System Password option, the system
password has been deleted. If Enabled is displayed for the System
Password option, press the <Alt><b> key combination to restart the
system, and then repeat steps 2 through 5.

Using the Setup Password

Assigning a Setup Password
You can assign (or change) a setup password only when the Setup Password
option is set to Not Enabled. To assign a setup password, highlight the Setup
Password option and press the <+> or <–> key. The system prompts you to
enter and verify the password. If a character is illegal for password use, the
system beeps.
NOTE:
The setup password can be the same as the system password. If the two
passwords are different, the setup password can be used as an alternate system
password. However, the system password cannot be used in place of the setup
password.
You can use up to 32 characters in your password.
As you press each character key (or the spacebar for a blank space), a placeholder
appears in the field.
The password assignment is not case-sensitive. However, certain key
combinations are not valid. If you enter one of these combinations, the system
beeps. To erase a character when entering your password, press <Backspace> or
the left-arrow key.
After you verify the password, the Setup Password setting changes to Enabled.
The next time you enter the System Setup program, the system prompts you for
the setup password.
A change to the Setup Password option becomes effective immediately
(restarting the system is not required).
Operating With a Setup Password Enabled
If Setup Password is set to Enabled, you must enter the correct setup password
before you can modify most of the System Setup options. When you start the
System Setup program, the program prompts you to enter a password.
48
Using the System Setup Program