Dell PowerEdge NM176 Hardware Owner's Manual page 27

Table 1-4. System Messages (continued)
Message
SATA Port 0/1/2
hard disk not found
Sector not found
Seek error
Seek operation
failed
Shutdown failure
The amount of
system memory has
changed.
Time-of-day clock
stopped
Causes
SATA Port 0/1/2 set as Auto,
no disk installed.
Faulty diskette or hard
drive.
Shutdown test failure.
Faulty memory module.
Information only, if you
have changed the memory
configuration.
Faulty memory module.
Faulty battery; faulty
system board.
Corrective Actions
Run the System Setup
program to correct the
settings. See "Using the
System Setup Program" on
page 35.
See "Troubleshooting a
USB Device" on page 102
or "Troubleshooting a Hard
Drive" on page 111 for the
appropriate drive installed
in your system.
Ensure that all memory
modules are properly
installed. See
"Troubleshooting System
Memory" on page 108. If
the problem persists, see
"Getting Help" on
page 127.
See "Troubleshooting
System Memory" on
page 108. If the problem
persists, see "Getting Help"
on page 127.
See "Troubleshooting
System Memory" on
page 108. If the problem
persists, see "Getting Help"
on page 127.
See "Troubleshooting the
System Battery" on
page 106. If the problem
persists, see "Getting Help"
on page 127.
About Your System
27