Application:
FOR 2014-2017 Toyota Highlander
Item
1
Driver side running board
2
Passenger side running board
3
Driver Front Mounting Bracket(DFM)
4
Passenger Front Mounting Bracket(PFM)
5
Driver Center Mounting Bracket(DCM)
Passenger Center Mounting Bracket (PCM)
6
Driver Rear Mounting Bracket (DRM)
7
8
Passenger Rear Mounting Bracket(PRM)
9
Support Plates
DRM
DCM
Step
REMOV E CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRES ENT. READ INSTRUCTIONS
1
CAREFULLY BEFORE STARTING INSTALLATION.
Start on the passenger side of the vehicle, locate the (9) rubber plugs along the lower body panel. From
the front ,remove the 3rd and 4rd round plugs (Figure 1). Select (2) Bolt plates, (Figure 2). Check the
location for body sealant and scrape away excess as necessary, (Figure 3). Insert each Bolt Plate into
2
the factory hole with the long end of the plates facing each other, (Figure 1&3). Hold a Front Bracket
over the Bolt Plates and line up the (2) mounting holes, (Figure 4). Secure the Bracket to the Bolt
Plates with (2) M10 Flat Washer, (2) M10 Lock Washer and (2) M10 Hex Nuts, (Figure 4). Snug but do
not tighten hardware at this time.
Next, select (1) Support Plate, (1) M10 Hex Nut and (1) M10 Hex Bolt, (Figure 5). Thread the M10 Hex
Nut all the way down the long Hex Bolt. Screw the Hex Bolt and Nut a few threads into and through the
Nut welded onto the back tab on the front Bracket. Insert the Support Plate with the welded socket
3
facing down, into the space between the Front Bracket and the floor panel behind the pinch weld,
(Figure 4 5 &12). Tighten the Hex Bolt into the socket on the Support Plate until the Plate is close to but
not touching the floor panel. Do not tighten hardware at this time.
Next, remove the rubber plug in the 5th (next) hole along the body panel. Repeat Steps 2-3 to install
4
the center Bracket, (Figure 6&7).
The instruction here is for your reference only. We strongly recommend the
professional installer for best result. We are not responsible for any damage
caused by the installation. Thank you for choosing our product!
iRunning Board Installation Instruction
Part Name
DFM
Installation Instruction
QTY
Item
1
10
M10 Bolt Plates
1
11
M10 Hex Bolts
1
12
M10 Flat Washers
1
13
M10 Lock Washers
1
14
M10 Hex Nuts
1
15
M6 Square Hex Bolts
1
16
M6 Flat Washers
1
17
M6 Nylon Lock Nuts
6
PRM
Page 1 of 5
REV: 20170601
Part Name
DCM
PFM
QTY
10
6
16
16
16
12
12
12
Need help?
Do you have a question about the iRunning IB20RIG5B and is the answer not in the manual?
Questions and answers