APS IB20RIG4B Installation Instruction

Application:
FOR 2010-2017 TOYOTA 4RUNNER LIMITED/ 2010-2013 TOYOTA 4RUNNER SR5/ EXCL.
2014-2017 SR5 & 2010-2017 TRAIL EDITION
Item
1 Driver side running board
2 Passenger side running board
3 Front Mounting Bracket (DFM/PFM)
Cent er & Rear Mounting Bracket （DCM/PCM)
4
8-1.25mm x 30mm Hex Bolts
5
DFM
Installation Procedure
Step
REMOV E CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRES ENT. READ INSTRUCTIONS
1
CAREFULLY BEFORE STARTING INSTALLATION.
Start installation on the passenger side of the vehicle, remove the existing (2) factory bolts located by
the front tire opening securing the factory rocker panel bracket to the vehicle,(Figure 1). Select (1)
Front Mounting Bracket. Hold the Front Bracket over the rocker panel bracket and line up the (2)
2
mounting holes. Secure the brackets to the vehicle using the included longer (2) 8mmx30mm HEX
Bolts, (2) 8mm Lock Washers and (2) M8 Flat Washers, (Figure 2). Do not tighten hardware at this
time.
The center and rear brackets are identical. Select (1) Center & Rear Bracket and repeat the procedure
3
as described in Step 2 to install it in the center mounting location, (Figure 3). NOTE: Install (1)
mounting bracket at a time. Do not tighten hardware at this time.
4 Repeat Step 3 for rear Mounting Bracket installation.
Carefully unwrap the Running Board and select passenger side Board. Select (6) Square Head Bolt.
Insert (3) Square Head Bolt into each channel on the bottom of the Running Board, (Figure 4). Slide
5 the Square Head Bolt forward or back to line up with the (3) previously installed Mounting Bracket,
(Figure 5). Hold the Running Board up to the vehicle at a slight angle and gently push it into position
against the rocker panel, (Figure 6). Line up the Square Head Bolt with the slots in the Brackets.
The instruction here is for your reference only. We strongly recommend the
professional installer for best result. We are not responsible for any damage
caused by the installation. Thank you for choosing our product!
iRunning Board Installation Instruction
Part Name
DCM
Installation Instruction
QTY Item
8mm Lock Washers
1 6
1 7 M8 Flat Washers
2 8 M6 Square Head Bolt
4 9 M6 Flat Washers
12 10 M6 Nylon Lock Nuts
PCM
Page 1 of 5
REV: 20170601
Part Name
PFM
QTY
12
12
12
12
12