Shark POWERDETECT NEVERTOUCH RV2800WD Series Owner's Manual page 15

MAINTENANCE
CAUTION: Turn off power and remove the robot's water tank before performing any maintenance. To turn
the robot power off, press and hold the DOCK icon
CLEANING THE ROBOT FILTER
For optimal suction power, clean the filter inside the robot's dust bin.
1. Remove and empty the dust bin. Clean any hair or
debris off the back of the dust bin.
CLEANING THE SIDE BRUSH
CLEAN SIDE BRUSH AS NEEDED.
s h a r kc l e a n . c o m
on the robot for 5-7 seconds.
2. Every time you empty the dust bin, slide the filter
out and lightly tap it over a trash can to remove
any dust and dirt. Use a dry cloth or soft brush to
remove any remaining debris.
DO NOT use water or soap to clean this filter as this will
cause damage.
1. Remove the side brush from the robot.
2. Carefully unwind and remove any string or hair
wrapped around the brush or gear.
3. Gently wipe brush with a dry cloth. To reinstall,
snap the brush over the peg. Spin the brush
manually to make sure it is installed correctly.
MAINTENANCE MAINTENANCE
CAUTION: Turn off power and remove the robot's water tank before performing any maintenance. To turn
the robot power off, press and hold the DOCK icon
CLEANING THE SENSORS
IMPORTANT: The robot uses cliff sensors to avoid stairs and other steep drops. Sensors may work less effectively when
they are dirty. For best results, clean sensors once every 30 days or as needed.
CAUTION: Turn off power before performing any maintenance. To turn the base power off, simply unplug it
from the electrical outlet.
CLEANING THE BASE CHARGING CONTACTS
on the robot for 5-7 seconds.
CLEAN SENSORS AND CHARGING CONTACTS
AS NEEDED.
• The sensors on the robot require occasional
maintenance.
• With a dry cloth or cotton swab, gently dust off
the sensors located on the bottom and sides of the
robot.
• Locate the charging contacts on either side of the
base.
• These sensors require occasional maintenance.
• With a dry cloth, gently dust off both charging
contacts on the base, removing any dust or debris
that might impact robot docking performance.
s h a r kc l e a n . c o m