Shark POWERDETECT NEVERTOUCH RV2800WD Series Owner's Manual page 8

IMPORTANT: Be sure to charge the robot completely before its first clean so that it can explore, map, and
clean as much of your home as possible. It may take up to 4 hours* to fully charge your robot.
To TURN THE ROBOT ON: Slide the robot up the
ramp on to the base or hold down DOCK icon
for 5 to 7 seconds, until the indicator lights turn on.
After 10 to 15 seconds, the robot will begin to
evacuate dust and debris into the base.
NOTE: When manually placing the robot on the base, make sure the Charging Contacts on the back end of the robot are
touching the ones on the base.
NOTE: When picking up the robot, be careful not to place fingers between the bumper and the back of the robot.
*Battery charge time may vary.
s h a r kc l e a n . c o m
CHARGING
When the cleaning cycle is complete, or if the battery
is running low, the robot will search for the Self-
Empty Base. If the robot doesn't return to the base,
its charge may have run out.
ROBOT BUTTONS
DRY CLEAN BUTTON
If the robot is on the base,
press the DRY icon on the
robot
clean. Press again to pause
the cleaning session.
For a 5x5 ft spot clean, press
and hold the DRY icon
5-7 seconds.
WET CLEAN BUTTON
If the robot is on the base,
press the WET icon
the robot for a whole-home
clean. Press again to pause
the cleaning session.
For a 5x5 ft spot clean, press
and hold the WET icon
5-7 seconds.
DOCK BUTTON
To turn on/off your robot,
press the DOCK icon
the robot for 5-7 seconds.
Short press the DOCK icon
to send the robot back to
the base.
RECHARGE & RESUME
Press and hold the DOCK
icon for 15 seconds to turn
Recharge & Resume ON or
OFF.
The Recharge & Resume function is turned ON
by default. The robot will run until it reaches low
battery. If its cleaning mission is not complete
at that time, it will return to the base, recharge,
and then pick up where it left off.
for a whole-home
for
on
for
on
s h a r kc l e a n . c o m