Windows Configuration; Configuring Tcp/Ip; Configuring A Windows 95/98/Me Computer; Configuring A Windows 2000 Computer - Ricoh Priport HQ9000 Network Manual

4. Windows Configuration

Configuring TCP/IP

This section describes how to configure Windows for TCP/IP and IPP.

Configuring a Windows 95/98/Me Computer

Follow the procedure below to configure a Windows 95/98/Me computer to use
TCP/IP.
A
Open [Control Panel], and then double-click the Network icon. Make sure
[TCP/IP] is selected in the [The following network components are installed] box on
the [Configuration] tab.
Note
❒ Select TCP/IP if it is not already selected.
❒ If TCP/IP is not installed, click [Add...] on the [Configuration] tab to install it.
For more information about installing TCP/IP, see Windows 95/98/Me
Help.
B
Click [Properties].
C
Configure TCP/IP using the appropriate IP address, subnet mask, and other
settings.
Check with the network administrator that the settings are correct.

Configuring a Windows 2000 Computer

Follow the procedure below to configure a Windows 2000 computer to use
TCP/IP.
A
On the [Start] menu, point to [Settings], and then click [Network and Dial-up Con-
nections].
B
Double-click [Local Area Connection]. On the [General] tab, click [Properties].
C
Make sure [Internet Protocol (TCP/IP)] is selected in the [Components checked are
used by this connection] box on the [General] tab.
Note
❒ Select TCP/IP if it is not already selected.
❒ If TCP/IP is not installed, click [Install] on the [General] tab to install it. For
more information about installing TCP/IP, see Windows 2000 Help.
15