Ricoh Priport HQ9000 Network Manual page 97

SLP
Use the "slp" command to configure SLP settings.
You can search the NetWare server using SLP in the PureIP environment of
NetWare5/5.1, 6. Use the "slp" command to configure the value of TTL used by
the SLP multi-cast-packet.
Note
❒ The default value of TTL is "1". A search is executed only within a local seg-
ment. If the router does not support multi-cast, the settings are not available
even if the TTL value is increased.
❒ The acceptable TTL value is 1 - 255.
msh> slp ttl {1 - 255}
Setting IEEE 802.11b
Use the "wiconfig" command to configure IEEE 802.11b interface settings.
Limitation
❒ You can make settings when installing the IEEE 802.11b interface unit.
❖ View settings
The following command displays the current IEEE 802.11b interface settings.
msh> wiconfig
The following command displays the IEEE 802.11b card information.
msh> wiconfig cardinfo
Note
❒ If the IEEE 802.11b interface is not working correctly, the IEEE 802.11b card
information is not displayed.
Remote Maintenance by telnet
9
91