Ricoh Priport HQ9000 Network Manual page 96

Appendix
SMB
Use the "smb" command to configure or delete the NetBEUI settings such as the
computer name or workgroup name.
msh> smb parameter
Parameter
comp
group
comment
notif {on | off}
clear comp
clear group
clear comment
Note
❒ You cannot use a computer name starting with "RNP" or "rnp".
ROUTE
Use the "route" command to control the routing table.
This command allows you to configure and display routing information. You
can change the network configuration from remote computers using this com-
mand.
Note
❒ The maximum number of routing tables is 16.
9
Commands
route add {host | net}
*1
destination
route delete {host | net}
*1
destination
route get {destination
route active {host | net}
*1
destination
route add default gateway
route flush
*1
IP address
90
Settings
Your computer name consisting of up to 15 characters
Workgroup name consisting of up to 15 characters
Comment consisting of up to 31 characters
You can enable or disable notification of print job completion.
Clears the computer name
Clears the Workgroup name
Clears comment
Topics of setting
Adds a host/network route to "destination", and a gateway ad-
dress to "gateway" in the table. Host becomes the default.
*1
gateway
Deletes a host/network route from the table. Host becomes the
default.
Displays only route information corresponding to a specified
*1
}
destination. When the destination is unspecified, all routing in-
formation is displayed.
You can turn the specified destination on or off. Host becomes
the default.
on | off
*1 You can set the default gateway address.
Deletes all routing information.