Flashforge AD5X User Manual page 14

2. After loading the filaments, please manually configure the filament information. Click on the
corresponding filament channel, and then click [
and color. Click [Ok].
Note: The device can only print if the filament type of the sliced file matches the configured
(actually loaded) filament type.
Note
*Expanded Filament Loading:
When IFS is not in use (note: single filament mode can only be used when the IFS signal cable is
disconnected; when the IFS signal cable is connected, the device will load filament in the IFS mode
by default), users can click on the filament and select the loading button on the screen to load it
(the operation is the same as with IFS).
*This device uses IFS mode for filament loading by default.
] to select the corresponding filament type
12