Cleaning The Motor Protection Filter - Morphy Richards IB70191 Instructions Manual

70191rev2 17/1/06
Cleaning the foam
lid filter
DO NOT USE THE PRODUCT WITHOUT
THE FOAM FILTER FITTED
1 To clean the foam filter first remove the
dust container cover.
2 Turn the cover upside down.
3 Gently push out the cover edge to release
the four edge clips.
4 Lift off the cover base
5 Remove the foam filter
6 Wash the foam in cold water. DO NOT
USE DETERGENTS.
7 Leave to air-dry
IMPORTANT: The foam must be thoughly
dry before re-fitting.
8 Place the foam inside the lid, then fit the
lid cover ensuring all edge clips are fully
engaged.
9 Re-fit to the dust bag container.
Cleaning the motor
protection filter
IMPORTANT: Never use the appliance
without the motor protection filter installed,
otherwise damage to the motor may occur
which would not be covered by the
guarantee.
1 Unclip and remove dust container cover.
2 Take out the filter and clean (by shaking)
or wash.
3 To wash the filter, gently wash in warm
water and leave to air dry. Do not use
detergents. Ensure the filter is fully dry
before replacing into the machine.
4 Close the filter holder and place back into
position before removed.
1:31 PM Page 7
7