Advertisement
70515+70516 Rev 1
19/5/04
3:59 PM
Page 1
GrimeBuster steam cleaner
Please read and keep these instructions
getting the best from your
new cleaner...
Please study all instructions carefully before use.
This product is also supplied with a user guide CD ROM.
No steam
• Check the power supply.
• Check the steam switch is set to the on position.
WARNING: If the cleaner has been boiled dry it must be
switched off for a few minutes to allow the safety cut-out
to reset.
• Check water is in the tank.
• The cleaner may need descaling. We recommend the use of
filtered water to reduce the scale.
(In hard water areas the cleaner will require regular descaling.
Follow the instructions on page 8.)
www.morphyrichards.co.uk
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Morphy Richards GrimeBuster steam cleaner
Summary of Contents for Morphy Richards GrimeBuster steam cleaner
- Page 1 70515+70516 Rev 1 19/5/04 GrimeBuster steam cleaner getting the best from your new cleaner... Please study all instructions carefully before use. This product is also supplied with a user guide CD ROM. No steam • Check the power supply. • Check the steam switch is set to the on position.
-
Page 2: Important Safety Instructions
• Repairs to electrical appliances are only to be undertaken by trained personnel. Unprofessional repairs can be dangerous for users. • Use only genuine Morphy Richards spare parts and accessories. • If the electrical cable becomes damaged the complete cable assembly must be replaced. - Page 3 70515+70516 Rev 1 19/5/04 Features ⁄ Filler cap ¤ Heater on/off button ‹ Steam on/off button › Machine socket fi ‘Heater on’ indicator light fl ‘Steam ready’ indicator light ‡ ‘Refill’ indicator light · ‘Steam indicator’ light ‚ Carrying handle „...
-
Page 4: Filling The Boiler
70515+70516 Rev 1 19/5/04 Setting up your steam cleaner Filling the boiler 1 Unscrew the filler cap ⁄ anti-clockwise. 2 Fill the boiler with a maximum of 1.8 litres of water by using the funnel Ï provided. A 3 Do not use any detergents. 4 Screw the filler cap ⁄... - Page 5 70515+70516 Rev 1 19/5/04 To fit the connector 1 Push the connector end, holding it upside down, fully into the brush inlet E. 2 Twist the connector a turn, until it is in place. F • The fit between the connector and the tubes and/or handle is tight to ensure no steam leaks.
-
Page 6: Switching The Unit Off
70515+70516 Rev 1 19/5/04 Re-filling When the ‘refill’ light ‡ turns red, there should be no steam available for release. The boiler needs to be refilled. 1 Switch off the boiler heater by pressing the heater on/off button ¤. 2 If there is pressure in the boiler, the filler cap ⁄... - Page 7 70515+70516 Rev 1 19/5/04 1 The jet nozzle can be attached either directly to the handle or via the extension tubes. • The closer you hold the jet nozzle to the object to be cleaned, the better the cleaning results will be. •...
-
Page 8: Maintenance
70515+70516 Rev 1 19/5/04 Wall paper stripper ˆ * (certain models only) J 1 Fit wallpaper stripper directly to the hose handle, locking into place. J 2 Press the steam on/off button ‹. The orange light will come on. 3 Place the wallpaper stripper with its entire surface on the edge of a sheet of wallpaper. -
Page 9: Troubleshooting
Very long heat up time. Loud whistling noise accompanied by steam from the rear of the machine. If you encounter any other problems with the product, contact our Morphy Richards helpline. 3:59 PM Page 9 Possible cause No electrical supply. -
Page 10: Two Year Guarantee
24 months of original purchase, you should contact the Helpline number quoting Model number and Serial number on the product, or write to Morphy Richards at the address shown. You will be asked to return the product (in secure, adequate packaging) to the address below along with a copy of proof of purchase.
Need help?
Do you have a question about the GrimeBuster steam cleaner and is the answer not in the manual?
Questions and answers
What is the dial on the top of the steamer for?