Eads Telecom Connexity M730 User Manual page 73

Choosing the display language
Messages broadcast by the display are from two sources: messages from the set and messages
specific to the associated system.
If this terminal is connected with a recent system, this information is not for you; the language
synchronization is supplied automatically by the system.
Consult your system operator if you are in any doubt.
In the other case, a specific menu allows you to select the language of the messages provided by
the set, in order to proceed to the synchronization (language used by the set with regard to lan-
guage programmed in the system).
Choosing the set
internal message
language:
This setting is used to choose the language in which internal
messages of the set are displayed.
1 - Press key.
The display indicates « PROGRAMMING».
2 - Press the key until the display shows " LANGUAGE".
LANGUAGE
3 - Press the key to access to the language selection.
The display presents the first available language.
4 - Press successively the
guages, if necessary.
5 - Press the key to validate the displayed language.
Two beeps are emitted to confirm the language setting.
Settings
key to display the other lan-
67