Eads Telecom Connexity M730 User Manual page 30

The private directory
Modifying or deleting a record from the private directory
Once a record has been programmed, you can modify or delete it.
Modifying a record:
24
4 - Enter the telephone
obtaining the external line (up to 23 digits without any pause).
Note: If the name or number is already stored in the directory,
the display shows the message «ALREADY REGIST.».
. If you want to save an access sequence (e.g. secret code or
interrogation code), you must press
code. You must also press
necessary.
. If you make a mistake, press the
character to be replaced (cursor under the character) then enter
the new character.
5 - Press the key to confirm the number.
The display shows the saved name.
Note: You can use the
sequence.
While consulting a record,
1 - Press the key successively to show the "MODIFY?"
message.
2 - Press the key .
The display shows the saved name.
3 - Press the or
replaced (the cursor will be underneath the character), then
enter the new character(s).
. If you do not want to modify the name, press the
directly .
4 - Press the key to confirm the modification of the name.
The display prompts you to modify the number.
5 - Proceed in the same way as for modifying a name.
. If you do not want to modify the number press the
directly .
number, including the code for
before entering the
to insert a pause in this code, if
or
red key to abort or terminate a
keys to highlight the character to be
keys to select the
key
key