Troubleshooting - Timberk HOME INTELLECT T-HU3-A102E-WF Instruction Manual

13. TROUBLESHOOTING

Table 2
Malfunction
Poor atomizing (insufficient
productivity)
No atomizing
There is white patches from the
water on objects around the
humidifier (salts, separating out
from water)
Steam has a bad smell
During the operation of the
device, condensate is forming
on the upper part of the
humidifier
and on surrounding objects
48
Possible cause
The unit is operating in
the low atomizing mode (low
atomizing frequency)
The atomizer is clogged
Temperature of water in the
tank is low
The power cord is poorly
connected to the outlet
White patches have
formed on the membrane
There is a lot of salts in the water
(calcium and magnesium)
Stale water is used
Remains of stale water or waste
have accumulated in the unit's
case or the atomizer
High humidification intensity
is set.
Room humidity and
room temperature are high
Solution
It is not a malfunction. Switch
the device into the intensive
mode of operation
Clean the atomizer.
Set maximum productivity
mode. The humidifier's
productivity will go up after a
while.
Connect the power cord into
the outlet carefully
Clean the humidifier's
membrane with a special brush
Use filtered water
Clean the unit according to
the cleaning and servicing
instructions and fill the tank
with fresh and filtered water
Decrease the humidification
intensity
IM2024
ENG