Creone Keybox 9000 Basic Instruction Manual page 9

7. Programming new PIN codes
Programming new PIN codes always requires the
service code to be entered in order to access pro-
gramming mode. If one or more expansion cabinets
are connected the codes are inputted by entering
the number of the door counting from the top down
for each expansion cabinet. PIN code shall have 1-8
characters.
Example of programming new PIN code:
Enter the relevant service code.
301042#
Note that the light now starts
flashing at shorter intervals.
*11*door*PIN code#
Enter *11* to access the add new
code operation. Then select which
door you wish to program followed
by *. Then the code you wish to use
for this door. Finish with #
Repeat the procedure to program more doors before
you exit the service mode.
Exit service mode. Note that the
*89#
light now starts flashing at longer
intervals.
You can now test your code.
Remember that when you enter the PIN code on
Keybox you must finish with # to the door to be
opened.
Example:
Enter the relevant service code.
301042#
Note that the light now starts
flashing at shorter intervals.
You have now programmed
*11*1*1111#
door 1 with code 1111.
You have now programmed
*11*6*4545#
door 6 with code 4545.
*11*12*1010# You have now programmed
door 12 with code 1010.
Exit service mode.
*89#
9
9000 B series