Creone Keybox 9000 Basic Instruction Manual page 23

8.1.2 – Remove Code
Press 2 for REMOVE CODE
Enter the code you wish to remove and finish
with # The message CODE ERASED is shown
in the display.
To remove more codes, enter code and press #.
Press * to go back to menu.
8.1.3 – Display codes
Press 3 for DISPLAY CODES
All codes in the cabinet are now displayed here.
Press 0 to move back in the menu.
8.1.4 – Service Code
Press 4 for SERVICE CODE
Enter code and press #. You automatically return to
the menu.
NB! The service code is the code you use to access
the programming position. This is the most important
code to enable operation of KeyBox. If this code is
forgotten you have to reset KeyBox, then all previous
programming will be deleted.
8.1.5 – Extra service code
Select 5 for EXTRA SERVICE CODE
This code has the same function as in the section
before. You can then have two different codes to use
to program KeyBox.
8.1.6 – Erase all codes
Select 6 for ERASE ALL CODES
You are now asked ARE YOU SURE? Press # to
confirm and 0 to cancel.
23
9000 S series