8. Delete codes
Below is a description of how to remove PIN codes
for opening doors. The service code cannot be dele-
ted in any circumstances. It can only be changed by
inputting a new service code, see chapter 6.
The procedure for deleting a particular PIN code is:
301042#
*12*PIN code you wish to delete#
9. Setting magnet time (opening time)
This function is set at 3 seconds on delivery, but can
be changed from 1 to 10 seconds.
To change magnet time:
301042#
9000 B series
9000 B-serien
Enter the relevant service code.
Note that the light now starts flashing
at shorter intervals.
Enter *12* to access the delete
operation. Then the PIN code you
wish to remove. Finish with #.
Enter the relevant service code.
Note that the light now starts
flashing at shorter intervals.
Exit service mode. Note that the
*89#
light now starts flashing at longer
intervals.
To delete all codes:
Enter the relevant service code.
301042#
Note that the light now starts flashing
at shorter intervals.
Enter *00# for the delete all PIN
*00#
codes operation.
Exit service mode. Note that the
*89#
light now starts flashing at longer
intervals.
Enter *69* for the change magnet
*69*1-10#
time operation, then the number of
seconds for how long the magnet is
to be disabled.
Exit service mode. Note that the
*89#
light now starts flashing at longer
intervals.
10
Need help?
Do you have a question about the Keybox 9000 Basic and is the answer not in the manual?