Creone Keybox 9000 Basic Instruction Manual page 13

13. Mounting backup battery (Accessory)
If not factory-mount:
The backup battery consists of a rechargeable battery
and a printed circuit card, as well as the supplied
cable with which to connect to the main card.
Do as follows:
• Disconnect the power to the cabinet.
• Attach the backup battery in the cabinet's top left
corner. There are pre-drilled holes in which to
secure the backup battery.
• Remove the cable running between the power
supply unit and the main card, one black and
14. Quick guide
This is a summary of all the operations and how to
carry out the programming.
301042#
Codes
*11*door number*code# Add a new PIN code.
*12*code#
*00#
Enter the relevant service
code
See chapter 7.
Delete a PIN code.
See chapter 8.
Delete all PIN codes.
See chapter 8.
one red cable.
• Now connect the supplied black cable and red
cable to the power supply unit, red cable to + and
black cable to -. Then connect this to the backup
battery's printed circuit card.
• Then connect the black, red, blue and white cable
from the printed circuit card to the backup battery
and to the main card. NB! The cabinet is now
powered via the battery.
• Then power up the cabinet.
Backup battery must be installed by a specialist.
Settings
*99*service code#
*69*time in seconds# Change magnet time.
*59#
*01#
*89#
13
Change the service code.
See chapter 6.
See chapter 9.
Check key compartments.
See chapter 10.
Reset – Total resetting of
cabinet. See chapter 11.
Exit service mode.
9000 B series 9000 B-serien