Page 2
Waterproof Requirements Please waterproof cables in accordance with the following instructions. User shall assume all responsibility for device damage caused by water due to improper waterproof measures. NOTE! • Before you start, connect all the needed cables and cut off the copper wires for the cables that you don't use.
5. (Optional) After the waterproof treatment is completed, put the cables into a waterproof junction box (purchased separately). CAUTION! • The cable connector must not be exposed and must be kept away from water. • Restore and fasten the device after dismounting. •...
abnormally. If it is required to lengthen the power cable, lengthen the cable between the power adapter and the mains. ⚫ Do not overbend the cables during the installation, otherwise, poor cable contact may cause malfunction. ⚫ When connecting to an external interface, use an existing connection terminal, and ensure that the cable terminal (latch or clamp) is in good condition and properly fastened.
1. Base plate 2. Housing 3. Lens 4. Infrared LED 5. Power interface(12V DC) 6. Ethernet interface Mount Your Camera (Optional) Insert Micro SD Card For cameras that support Micro SD, you need to insert the Micro SD card after opening the bottom cover of camera.
3. Install the base plate and the camera. 4. Mount your camera. Mount the housing with Connect cable and protect it with install mark aligned. waterproof tape and attach dome to ceiling with taping screws. 5. Adjust the monitoring direction. 6.
Page 7
NOTE! • DHCP is enabled by default. If a DHCP server is used in your network, your camera may be assigned an IP address, and you need to use the assigned IP address to log in. • You may need to install a plug-in at your first login. Please follow the on-screen instructions to complete the installation and then open the browser again to log in.
Page 8
Disclaimer and Safety Warnings Copyright Statement No part of this manual may be copied, reproduced, translated or distributed in any form by any means without prior content in writing from our company (referred to as us hereafter). The product described in this manual may contain proprietary software owned by our company and its possible licensors.
Page 9
pecuniary, coverage, exemplary, subsidiary losses, however caused and on any theory of liability, whether in contract, strict liability or tort (including negligence or otherwise) in any way out of the use of the product, even if our company has been advised of the possibility of such damages (other than as may be required by applicable law in cases involving personal injury, incidental or subsidiary damage).
Page 10
⚫ Store or use the device in a proper environment that meets environmental requirements, including and not limited to, temperature, humidity, dust, corrosive gases, electromagnetic radiation, etc. ⚫ Make sure the device is securely installed or placed on a flat surface to prevent falling. ⚫...
Need help?
Do you have a question about the M-44-FW-L and is the answer not in the manual?
Questions and answers