Advertisement
Advertisement
Table of Contents
Related Manuals for advidia M-44-V-V3
Summary of Contents for advidia M-44-V-V3
- Page 1 M-44-V-V3 Varifocal Turret Network Camera Quick Guide V3.00...
- Page 2 Waterproof Requirements Please waterproof cables in accordance with the following instructions. User shall assume all responsibility for device damage caused by water due to improper waterproof measures. NOTE! • Before you start, connect all the needed cables and cut off the copper wires for the cables that you don't use.
-
Page 3: Packing List
DC interface Plug 5. (Optional) After the waterproof treatment is completed, put the cables into a waterproof junction box (purchased separately). CAUTION! • The cable connector must not be exposed and must be kept away from water. • Restore and fasten the device after dismounting. •... -
Page 4: Maintenance
abnormally. If it is required to lengthen the power cable, lengthen the cable between the power adapter and the mains. Do not overbend the cables during the installation, otherwise, poor cable contact may cause malfunction. When connecting to an external interface, use an existing connection terminal, and ensure that the cable terminal (latch or clamp) is in good condition and properly fastened. -
Page 5: Cable Connection
Cable Connection The tail cable may vary with device model. The figure below is for illustrative purposes only. DC12V IN 1. Base plate 2. Housing 3. Lens 4. Illuminator 5. Ethernet interface 6. Power interface... -
Page 6: Mount Your Camera
Mount Your Camera (Optional) Insert Micro SD Card For cameras that support Micro SD, you need to insert the Micro SD card after opening the bottom cover of camera. Do not hot plug the Micro SD card after it is inserted. Otherwise the camera or the SD card might be damaged. - Page 7 3. Connect the cable and then secure the 4. Mount the housing. bottom ring. Align the screw hole on the housing with the tail cable outlet on the base, attach the Connect cable and protect it with housing gently then rotate waterproof tape, attach bottom ring to clock/counterclockwise at least 8 degrees to...
-
Page 8: Access Your Camera
Access Your Camera Before you begin, check that: Your camera is operating properly and connected to the network. Follow these steps to access your camera through the Web: 1. Open your browser, input the IP address of your camera in the address bar and then press Enter to open the login page. - Page 9 Disclaimer and Safety Warnings Copyright Statement No part of this manual may be copied, reproduced, translated or distributed in any form or by any means without prior consent in writing from our company (referred to as us hereafter). The product described in this manual may contain proprietary software owned by our company and its possible licensors.
- Page 10 pecuniary, coverage, exemplary, subsidiary losses, however caused and on any theory of liability, whether in contract, strict liability or tort (including negligence or otherwise) in any way out of the use of the product, even if our company has been advised of the possibility of such damages (other than as may be required by applicable law in cases involving personal injury, incidental or subsidiary damage).
- Page 11 Store or use the device in a proper environment that meets environmental requirements, including and not limited to, temperature, humidity, dust, corrosive gases, electromagnetic radiation, etc. Make sure the device is securely installed or placed on a flat surface to prevent falling. ...
- Page 12 Regulatory Compliance FCC Statements This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Caution: The user is cautioned that changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
Need help?
Do you have a question about the M-44-V-V3 and is the answer not in the manual?
Questions and answers