Subscribe to Our Youtube Channel
Related Manuals for Regulus PSW 200
Summary of Contents for Regulus PSW 200
- Page 1 Owners Manual ACCUMULATION TANKS PSW 200, PSWF 300, PSWF 500, PSWF 800, PSWF 1000, PSWF 1500, PSWF 2000, PSWF 3000, PSWF 4000, PSWF 5000 v. 1.2...
-
Page 2: Table Of Contents
CONTENTS 1. Description ..............................1.1 Models ............................... 1.2 Tank protection ........................... 1.3 Thermal insulation ..........................1.4 Connection points on the tank ......................1.5 Packing ............................... 2. General Information ............................3. Technical Data and Dimensions of PSWF (PSW) Models ................. 4. Operation ............................... 5. -
Page 3: Description
When more heat sources shall be combined, it is recommended to use an intelligent controller, e.g. Regulus IR09 KTP, for both the source and consumer sides of a heating circuit, i.e. also for charging and discharging an accumulation tank. -
Page 4: Technical Data And Dimensions Of Pswf (Psw) Models
3. Technical Data and Dimensions of PSWF (PSW) Models G 1/2“ G 1/2“ G 6/4“ G 6/4“ G 6/4“ G 1/2“ G 6/4“ G 1“ G 6/4“ G 1/2“ G 6/4“ G 6/4“ G 6/4“ G 1“ ø S ø T ø... -
Page 5: Operation
4. Operation This accumulation tank is designed for heating and accumulation of heating water in domestic or industrial applications, however always in closed pressure circuits with forced circulation. In the accumulation tank, heating water is heated up from several heat sources like various types of hot-water boilers, renewable energy sources (heat pumps, solar collectors), or electric heating rods. - Page 6 Example II. Solar collectors and a combination gas boiler. gas boiler with a hot water storage hot water cold water Example III. Solar collectors, a solid fuel boiler and el. heating rods. hot water cold water...
-
Page 7: Installation And Commissioning
When the upper flange is fitted with a properly sized heating coil, this tank can be used as a continuous water heater. This does not apply to PSW 200 that is not fitted with a top flange. For this reason installation of a heat exchanger for continuous water heating is not possible which means PSW 200 cannot be used as a domestic water heater. -
Page 8: Installing Insulation On The Tank
7. Installing Insulation on the Tank Instructions Product description Thermal insulation of soft polyurethane foam with a zipped PVC layer, or melamine or polystyrene boards with a batten and hard PS sheet, with a lid and a set of rosettes. Warning Insulation installation shall be done in two or three persons, depending on its size. - Page 9 Pictures showing how to mount soft-foam insulation with a PVC sheet on a storage water heater.
-
Page 10: Maintenance
It shall be dropped off at a Local Waste Recycling Center. Insulation shall be recycled as plastic and the steel vessel as scrap iron. 08/2008 REGULUS spol. s r.o. Do Koutů 1897/3 http://www.regulus.eu CZ-143 00 Praha 4 E-mail: sales@regulus.cz...
Need help?
Do you have a question about the PSW 200 and is the answer not in the manual?
Questions and answers