Endress+Hauser Micropilot FMR60B Brief Operating Instructions page 4

Requirements for the personnel
3 Requirements for the personnel
The personnel for installation, commissioning, diagnostics and maintenance must fulfill the
following requirements:
‣
Trained, qualified specialists must have a relevant qualification for this specific function
and task.
‣
Are authorized by the plant owner/operator.
‣
Are familiar with federal/national regulations.
‣
Before starting work, read and understand the instructions in the manual and
supplementary documentation as well as the certificates (depending on the application).
‣
Follow instructions and comply with basic conditions.
The personnel must fulfill the following requirements for its tasks:
‣
Trained, qualified specialists must have a relevant qualification for this specific function
and task.
‣
Are authorized by the plant owner/operator.
‣
Are familiar with federal/national regulations.
‣
Before starting work, read and understand the instructions in the manual and
supplementary documentation as well as the certificates (depending on the application).
‣
Follow instructions and comply with basic conditions.
The operating personnel must fulfill the following requirements:
‣
Are instructed and authorized according to the requirements of the task by the facility' s
owner-operator.
‣
Follow the instructions in this manual.
4 Intended use
Application and media
The measuring device described in these Operating Instructions is intended for continuous,
non-contact level measurement in liquids, pastes and sludges. Due to its operating frequency
of approx. 80 GHz, a maximum radiated peak power of <1.5 mW and an average output
power of <70 µW, unrestricted use outside of closed, metallic vessels is also permitted (for
example over basins or open channels). Operation does not pose any danger whatsoever to
humans and animals.
If the limit values specified in the "Technical data" and the conditions listed in the instructions
and additional documentation are observed, the measuring device may be used only for the
following measurements:
‣
Measured process variables: level, distance, signal strength
‣
Calculated process variables: volume or mass in vessels of any shape; flow rate through
measuring weirs or channels (calculated based on the level using the linearization
functionality)
To ensure that the measuring device remains in proper condition for the operation time:
‣
Use the measuring device only for media to which the process-wetted materials are
sufficiently resistant.
‣
Observe the limit values in the "Technical data".
4
Micropilot FMR60B HART
Endress+Hauser