Philips AVENT SCD971 Manual page 9

Caution
Declaration of conformity
Electromagnetic fields (EMF)
General Information
-
Do not install the appliance near any heat sources such as radiators, heat
registers, stoves or other apparatus (including amplifiers) that produce heat.
-
Make sure that your hands are dry when you handle adapters, plugs and the
mains cord.
-
Screw covers / rubber pad can detach from the appliance, check on a regular
basis.
-
All required markings on the Baby Unit, Parent Unit and power adapter are
located on the bottom of the Baby Unit, Parent Unit and power adapter.
-
The mounting accessory works best on a crib of which the square bar width is
between 15 mm to 32 mm. Avoid using it on round or soft rails.
-
If your baby crib has a round edge, the mounting bracket is best mounted to
the wall.
-
Remove the crib mount from your baby's crib and mount it on the wall when
your baby can pull themselves up on their own or show signs of standing.
Hereby, Philips Consumer Lifestyle B.V. declares that this product is in compliance
with the essential requirements and other relevant provisions of Directive
2014/53/EU. A copy of the EC Declaration of Conformity (DoC) is available online
at www.philips.com/support.
This Philips appliance complies with all applicable standards and regulations
regarding exposure to electromagnetic fields.
Lithium-ion rechargeable battery (2600 mAh)
Modulation type: IEEE 802.11 b/g/n
Operating frequency range: 2412 - 2472 MHz
Maximum radio-frequency power: ≤ 20 dBm e.i.r.p
*Supply unit:
Model: ASSA105x-050100 (x = E (EU plug) / x = B (UK plug))
Input: 100-240 V~, 50/60 Hz, 0.35 A
Output: 5.0 Vdc, 1.0 A, 5.0 W
Average active efficiency: ≥ 73.62 %
No-load power consumption: < 0.1 W
9
English