Memory Clearing; Метогус!Еагїпд; Callchannel Operation - Icom IC-1275A Instruction Manual

G MEMORY OPERATION
6-4 Memory clearing
This function is used to clear the information in each
memory channel.
1) Push [MEMO] to select MEMORY mode.
MEMO ^ NT.
co 9
о
o EEgEgBE QS
O o000 Ob
2) Rotate [DN MEMO UP] to select the memory channel
to be cleared.
Rotate [MEMO]
3) Push and hold [M-CL] until the speaker emits 3 beep
tones.
e The memory channel is now vacant.
M-CL
CAS 7 МЕМО
: [m]
E - i
6-5 Call channel operation
The transceiver has an independent call channel to easily
select your most-often-used frequency. A call channel can
be selected from VFO and MEMORY modes.
(1) Recalling the call channel
1) Push [CALL] to recall a call channel.
CALL
2) Push either [VFO] or [MEMO] to return to VFO or
MEMORY mode.
(2) Programming the call channel
1) Push and hold [CALL] until step 4.
Hm
o ESSEE =
©
EE]
pnaooooog
CALL
2) Set the desired information such as operating mode,
subaudible tone frequency or duplex information, when
required.
3) Rotate the tuning control to select the frequency as a
call channel.
4) Release [CALL].
5) Push and hold [MW] until the speaker emits 3 beep
tones.
e The selected frequency is programmed into the call
channel.