Envirovent ATMOS Installation Manual page 18

Wireless Remote Control
(Flashes Green)
Remote control in range
(Flashes Green)
•To indicate the current status of the unit:
-Press the remote-control button once and the LEDs will light up
according to the current status of the unit.
•To modify the air flow rate:
-Press the remote-control button once
-Further presses will then cycle the unit through each of the air flow
rate settings – 1 , 2 , 3 , 4
-Further presses will cycle back through the same settings
•To enable/disable the automatic comfort heater function:
-Press the remote-control button once.
-Press again for 5 seconds to disable comfort heater function.
-AUTO LED will flash red for 5 seconds.
-Press again for 5 seconds to enable comfort heater function.
-AUTO LED will light constant red for 5 seconds.
17
Atmos
SHOULD YOU ENCOUNTER ANY PROBLEMS
INSTALLING THIS UNIT, CALL US ON:
(Red)
Auto heater enabled (Constant Red)
Auto heater disabled (Flashing Red)
(Flashes Red)
Remote control not in range
(Flashes Red)
01423 810 810