Advertisement
Wiring Diagram Hook Up Procedure:
1) Insert the circular mini-din
connector of the source
component harness
through wire tie loop on
the main PCB and into
mini-din connector on
main PCB (fig.3).
2) Pull wire tie loop tight and
cut off excess.
3) Connect power harness to
mating connector on
video monitor.
4) Connect power harness to
vehicle' s electrical system
by tapping into an
accessory hot line.
5) Verify all functions of
system before final
mounting of finished
assembly.
Black: Ground
Black: Ground
Red: +12 VDC
Red: +12 VDC
(Accessory Cir.)
(Accessory Cir.)
TV antenna
TV antenna
(If applicable)
(If applicable)
Optional Remote Headphone Stations
Optional Remote Headphone Stations
Stereo Headphone
Stereo Headphone
Jack
Jack
Stereo Headphone
Stereo Headphone
Jack
Jack
Page 6 of 11
P/N 8010845
Rev.F Nov. 00
Mini din connector
(Source Component
harness)
Wire tie Loop
Mini-DIN
Receptacle
Power Harness
Power Harness
Item # 3a
Item # 3a
Power
Power
Connector
Connector
(2-pin)
(2-pin)
Green
Green
Spade
Spade
(Right+)
(Right+)
Terminals
Terminals
Black
Black
Spade
Spade
(Ground)
(Ground)
Terminals
Terminals
Gray
Gray
Spade
Spade
(Left+)
(Left+)
Terminals
Terminals
Antenna
Antenna
Connector
Connector
A/V Source definitions:
1 = Tuner
2 = VCP (left mini-din on main
3 = 2
Note: AUX Input overrides 2
VCP (DIN) Input when connector
is plugged into RCA jack
Figure 3
Figure 4
PCB
nd
VCP (right mini-dIn on
main PCB for game, future
DVD, etc.
nd
Advertisement
